Skip to content

BMS DEVICE FOR START BATTERYT

START BATTERY MONITORING SYSTEM

OUR MONITORING DEVICE, FOR STARTER BATTERY CONTROL

Device for monitoring the condition of lead acid batteries used to start the engine. The device can check the real capacity, State of Charge(SOC) and State of Health (SOH) of your batteries.

MAIN DIRECTIONS FOR USING A START BATTERY MONITORING DEVICE

Our Automatic Battery monitoring system (BatteryMS) built using advance microprocessor and proven intelligent software algorithm

Solution for engine starter batteries

  • Professional vehicles
  • Camper trailer and caravan
  • Marine – Boat , Yacht

THE PROCESS OF CHECKING STARTING BATTERIES WITH THE BATTERYMS DEVICE

Used to check the capacity of starting lead batteries – Lead acid, GEL or AGM.

In these solution, the “State of Health”(SoH) capacity which is calculated for starting the engine, is from 30 to 40% of the battery capacity, for example, a battery with a capacity of 100 A can start the engine as long as its residual capacity is above 30 – 40 Amperes.The device is permanently connected to the battery. Conducts battery analysis every few hours

INDICATIONS GIVEN BY THE DEVICE USING THE LED PANEL

A. Battery capacity and Battery “State of Health”(SoH) are normal.

  • The green LED is on – the battery capacity is optimal, no recharging is required.

B. If the engine is not running, for example when the vehicle is parked or stored in a garage, the battery discharges

  • Yellow LED is on – the capacity has dropped to 50% of the optimal battery capacity, it is necessary to start the engine to recharge the battery, it is recommended not to turn off the engine until the green LED lights up, Indication that the battery is charged more than 80 A

C. If the remaining capacity has dropped below the capacity required to start the battery(Battery is faulty)

  • The Red LED is on – the battery is not charging above 30% – 40% of the optimal capacity, the battery is completely unusable and must be replaced.

All of our products are tested

Product is in the field for over 10 years, passed few improvement loops and proved itself as highly reliable and needful device

During this time, several tens of thousands of battery monitoring systems were installed on various vehicles.

simple indication of battery charge level

BatteryMS states

  1. Battery full – constant signal Vbat appears when battery capacity is above 80%, and disappears when battery capacity is below 50%.
  2. Battery low – constant signal Vbat appears when battery capacity is below 50%, and disappears when battery capacity is above 80%.
  3. Replace battery – constant signal Vbat appears when battery capacity is below 30-40% of nominal capacity.

OUR ADVANTAGES

The things that make us special

fully automated

The BMS device is fully automated and easy to install and use

DESIGNS & INTERFACES​

Wide range of output options : visual signal of Pass/Fail indicator; dry contacts; optional network connection with RS232

low power consumption​

The BatteryMS device has an low power consumption. Device gets power from Battery

EASY TO USE​

The BatteryMS device has a simple 2-wire input connection to the battery