Skip to content

smart LED load device

fix car computer indicator failure

SMART LED LOADs FOR AUTOMOTIVE LIGHT

The does not heat up Smart electronic LED load module for vehicle (used instead of a load Dummy resistor)

The on-board computer of a car is equipped with a lamp condition monitoring system. When replacing standard light bulbs with LED ones, a problem arises. The fact is that low power consumption by LED car lamps is determined by the computer as a breakdown.

SLM – SMART ELECTRONIC LOAD MODULE

Our company has developed an innovative “Load module – intellectual device” that solved those problems! The module does not heat up and therefore does not require installation on a radiator (car body)

Technical data

  • Has 2 channels, replaces a pair of resistors
  • DC input voltage 12V, 24v
  • Load 21W
  • Weight 100g
  • Warranty 2 years

Advantages of our electronic load module compared to conventional load resistors

electronic load module

load resistors

SLM(Smart load module) does not heat up, this greatly facilitates and simplifies installation. No need to screw the module to the chassis
SLM(Smart load module) – Electronic load , fix error message caused by On-Board Computer after replacing incandescent light bulbs to LED
The computer failure-control systems will work properly and detect LED’s headlights fault.
Low energy consumption does not load the electric system of the vehicle
Cancel Hyper Flashing on Turning Signal
Reduces the of battary discharge, if for any reason the lights were not turned off.
Compact, lightweight and easy to install
Load resistor must be mounted on metal car chassis with screws.
The resistor can reach up to 100 – 170°C
Load resisor to fix error message caused by On-Board Computer after replacing incandescent light bulbs to LED
When the LED burns out, the computer does not give a signal that the burnt-out lamp needs to be replaced, since the load resistor continues to create a load
Depends on the power of the load resistor
Cancel Hyper Flashing on Turning Signal
High battery discharge, if for any reason the lights were not turned off.
Difficult installation of the load resistor

The does not heat up Smart electronic LED load module for vehicle (used instead of a load Dummy resistor)

Smart load 2 way 24 v module Installation schema

Connecting step

A LEDs must   be connected to out 1 & out 2. The IN1 & IN2  wire  may be connected to plus signal wire

6-pin socket

This block carries IN1 and IN2 light power signal   inputs and two OUT1 and OUT2 simulate load outputs to LED headlight

  1. Pin 1: 24V input for trailer light outputs. Protect with a 15 amp fuse, close to power source.
  2. Pin 2: 12V input for caravan auxiliary outputs. Protect with a 15 amp fuse close to the power source.
  3. Pin 3: 12V input for caravan auxiliary outputs. Protect with a 15 amp fuse close to the power source.
  4. Pin 4: Switched 12V output CAN controlled
  5. Pin 5: Switched 12V output CAN controlled
  6. Pin 6: Switched 12V output CAN controlled

OUR ADVANTAGES

The things that make us special

fully automated

The SLM device is fully automated and easy to install and use

DESIGNS & INTERFACES​

No False Bulb Failure Warnings

low power ​

The SLM device has an low power consumption. Device gets power from Battery

EASY TO USE​

The BatteryMS device has a simple 2-wire input connection to the battery